Sensormatic Intellex Provozní pokyny stáhnout pdf (Strana 209)

Intellex RMS Digital Video Management System

Installation and Use of Accessories 193

USB/RS-232 4-Port Expander-RDVEXP01

The Intellex USB/RS-232 4-Port Expander can be used to add serial ports to the

Intellex for the recording of text data.

Installation

Insert the USB cable of the port expander into one of the USB connectors in the rear of

the Intellex. It is not necessary to exit Intellex. The unit will recognize the new device

and a New Hardware Found message will appear briefly. The port expander is ready

to use.

After the Intellex RS-232 4-Port Expander has been installed, you may continue with

the setup of the text recording interface.

Serial Interfaces and Text Recording

Internal COM ports

Intellex RMS units have only one external serial port. It should be configured as COM

2 and is dedicated to the Touch Tracker interface. (The motherboard BIOS parameters

for COM 2 are I/O Address=2F8, Interrupt=IRQ3). Any additional serial ports must

be added by means of a USB serial port expander. Intellex RMS includes a RS-232

adapter that provides a single serial port connection.

Port Expanders

The serial port expander supported by Intellex is the Edgeport/4 by Inside Out

Networks. The Sensormatic part number is RDVEXP01.

Port Assignments

The serial port assignment is made by the Edgeport driver. It assigns COM ports

based on the serial number of the port expander. This means that if you plug one port

expander in and it is assigned serial port numbers COM 3-6, and you remove it and

plug in another port expander, it will then be assigned serial port numbers COM 7-10.

Always keep the same port expander with the same Intellex. If you switch Edgeports,

you must then renumber the COM port setup in Intellex.

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 237 238

Žádné komentáře

Sensormatic Intellex Provozní pokyny Strana 209