
Intellex RMS Digital Video Management System
Setup Options 93
To define the target area(s):
NOTE: You can configure one or more motion detection target areas at a time.
1. Set the Sensitivity: 1 to 100.
2. Move the mouse pointer to the image area.
3. Draw the boundaries of the target area.
NOTE: The target area must be enclosed to activate the filter.
a. Move the mouse pointer to the first corner of the target area and click the
mouse button.
All Click to activate all of the targets in the image
area.
Undo The unit stores each target area change in
memory. Click to remove the last change to
the target area.
Sensitivity The unit uses this setting to distinguish between valid and
invalid changes in the target area. At higher settings, small
changes trigger the filter. At lower settings, larger changes
are required to trigger the filter.
NOTE: When setting the filter sensitivity level, be sure to
consider the variations in lighting conditions, such as
exterior cameras recording from day to night or
interior cameras recording areas with lighting turned
on or off. To ensure that useful video is recorded or
filtered, nominal lighting in the area is required. You
should adjust the filter sensitivity for the lowest
lighting condition that applies (e.g., low sensitivity for
low lighting), and then test the filter to ensure its
proper activation. More lighting in the area will allow
higher sensitivity settings to be safely used.
1 … 100 Use this slide control to set the sensitivity for
the filter from minimum (1) to maximum
(100). The sensitivity number represents the
area of changing video relative to the active
zone area. Maximum sensitivity (1) requires
that a larger fraction of the active zone change
before the alarm is generated.
Default Click to reset the sensitivity to its default
middle position (50).
Komentáře k této Příručce